Queen incubator 54 cels

12 volt, temperature 36°C
1. Use the flexi cord provided to plug your portable incubator into a vehicle
accessory socket, transformer or battery charger.
(Use the accessory socket provided)
2. The left-hand indicator light comes on when the portable incubator is
connected to a 12 volt power source, set the temperature in controller .
(recommended temperature:32-34°C)
3. Preheat your portable incubator before use, when the correct temperature is reached, transfer queen cells into the foam tray. When operating on at the beginning, Portable Incubator may overheat briefly before settling back to normal operating temperature. Do not place cells in portable incubator until correct operating temperature is reached.
(An extension cord is available when using away from power source)
4. Queen cells are fragile and should be handled with care at all times. Avoid jolting or bouncing your portable incubator.
5. When the unit is unplugged the operator will need to ensure cells are not exposed to extreme changes in temperature.
In mild-warm weather, the unit could be left unplugged for short periods. In cold conditions the unit should be unplugged only briefly and the lid kept closed as much as possible. In hot sunshine care must be taken to avoid overheating. Keep your portable incubator shaded and never leave cells in direct sunlight. Temperature must not exceed 34 degrees Celsius.

Accessory sockets are easily fitted to most vehicles or tractors.
The foam tray can be removed and placed in a larger incubator overnight. Monitor the temperature and ensure it does not exceed 34 degrees Celsius. Keep a moist towel over the cells to keep humidity levels higher.
Added humidity is not normally necessary for short-term incubation of 10-day cells, but if desired, lightly spray some water over the foam or cover cells with a damp towel or cloth.
The portable incubator will operate on 12 volts DC power. It is polarity protected so the unit can be used on vehicles with positive and negative earthed batteries.
For connection to a battery charger, cut wires to battery clips and connect to accessory socket using electrical connector supplied. Battery clips may be re-joined using the same connector.
For connection to a transformer, the output voltage must be 12 volts. Connect output to the accessory socket using connector supplied. Before any connections are made to battery charger or transformer, ensure mains power is switched off.

Price per product (Piece): € 295,00

---